IMG 0782
Viewed: 184 times.
|
What im replacing (My Corsair H70)
Viewed: 496 times.
|
IMG 0779
Viewed: 183 times.
|
Use a little teflon tape around the threads of your nozzles to ensure a good seal. Only 2 or 3 wraps max, too much will cause problems
Viewed: 208 times.
|
Tighten nozzle by hand, and then about another 1/2 turn with a small wrench... DON'T OVER TIGHTEN
Viewed: 187 times.
|
Dry-fit your system in your rig to ensure you cut the correct hose length. Be sure to leave a little slack so you can work on the system if needed
Viewed: 193 times.
|
In using PCIce for coolant.. You can just use distilled water, and some anti-microbial additives, but this was cheap
Viewed: 216 times.
|
When you first fill the system it may get foamy due to the air being forced out of the rad and CPU block, but it clears up in a few hours
Viewed: 190 times.
|
Which makes this a perfect time to kick up and have a mid afternoon beer!
Viewed: 187 times.
|
ok, beer is done, time for cable management. Spend some time and do it right.. the more you can hide, the nicer things will look
Viewed: 233 times.
|
If your leak test went well, time to take the plunge and install that new system!
Viewed: 210 times.
|
Dont forget about the lights!
Viewed: 194 times.
|
1
