Got the table free from Craigslist, and wanted to make a poker table, so, here we go! Step 1) Traced the table to 1/2" OSB board

Step 2) Marked off outside lines for padded rail for the table. Rail is 4" wide.. 2" will overlap the table, 2" will overhang off the table

All my parts cut out from a single sheet of 1/2" OSB.

Table back in place temporarily, I glued the buttom of the rail to ensure when I was done, the rail would fit nicely over the table before securing it

Rail all complete! I routered the outside edge so you wont feel a sharp edge under the foam padding.. next step was to add the foam around it, and cover the whole thing with leather, then finish by securing it to the table itself with screws from underneith!

Table Complete!